Effect of heat treatment and zircon addition on the properties of low-cement castables based on recycled alumina grog

In this investigation, low-cement castables were prepared using 70% alumina grog aggregates obtained from crushed alumina brick waste. The aggregates were thermally treated at 1550 °C for 3 h. Four types of low-cement castables were prepared with various types of aggregates (alumina grog with or without thermal treatment) and fillers (with or without zircon addition), and they were evaluated in terms of their physical, thermal, and chemical properties. Microstructural analysis via scanning electron microscopy (SEM) was performed on the castables before and after slag attack. Compared to the other fabricated castables, the thermally treated alumina grog castables with zircon showed better physical properties, such as a higher bulk density, cold crushing strength, and modulus of rupture and a lower apparent porosity and water absorption. In addition, they had a higher positive linear thermal expansion, refractoriness under load, permanent linear change, and hot modulus of rupture. The results of the SEM with energy dispersive X-ray analysis of the prepared castables confirmed that the mullite and anorthite phases were predominant when zircon was not added and the zircon–mullite phase additionally appeared upon the incorporation of zircon. A quantitative elemental analysis via X-ray fluorescence spectroscopy was employed to determine the composition of the castables. X-ray diffraction analysis showed that the alumina grog castables had a high mullite and low anorthite content, and the thermally treated alumina grog had a high anorthite, low mullite, and high zircon content. The improvement in the mechanical and thermo-mechanical properties of the castables with thermally treated alumina grog and added zircon can be attributed to the formation of the zircon–mullite phase with a low mullite phase content.     

Generation,validation and application of dynamic load profiles in flow measurement using cavitating Herschel–Venturi nozzles

Today, utility meters for water are tested for measurement behavior at stable operating conditions at specified flow rates as part of the approval process. The measurement error that occurs during start and stop or when changing between flow rates may not be taken into account. In addition, there are new technologies whose measuring behavior under real-world conditions is only known to a limited extend. To take these facts into account, a new method has been developed and tested to determine the measurement behavior of water meters under dynamic load profiles as they occur in the real application. For this purpose, a test rig for flow rate measurement was extended by a cavitation nozzle apparatus and the generation of dynamic load profiles was validated. For the cavitation nozzles used, possible factors influencing the flow rate, such as temperature and purity of the water as well as the upstream pressure were investigated. Using different types of domestic water meters, the applicability of the dynamic test procedure was demonstrated and the measurement behavior of the meters was characterised.     

Simulations of NBI fast ion loss in the presence of toroidal field ripple on EAST

NBI fast ion losses in the presence of the toroidal field ripple on EAST have been investigated by using the orbit code GYCAVA and the NBI code TGCO. The ripple effect was included in the upgraded version of the GYCAVA code. It is found that loss regions of NBI fast ions are mainly on the low field side near the edge in the presence of ripple. For co-current NBIs, the synergy effect of ripple and Coulomb collision on fast ion losses is dominant, and fast trapped ions located on the low field side are easily lost. The ripple well loss and the ripple stochastic loss of fast ions have been identified from the heat loads of co-current NBI fast ions. The ripple stochastic loss and the collisioninduced loss are much larger than the ripple well loss. Heat loads of lost fast ions are mainly localized on the right side of the radio frequency wave antennas from the inside view toward the first wall. For counter-current NBIs, the first orbit loss due to the magnetic drift is the dominant loss channel. In addition, fast ion loss fraction with ripple and collision for each NBI linearly increases with the effective charge number, which is related to the pitch angle scattering effect.     

Estimating long-term time-resolved indoor PM2.5 of outdoor and indoor origin using easily obtainable inputs

To evaluate the separate impacts on human health and establish effective control strategies, it is crucial to estimate the contribution of outdoor infiltration and indoor emission to indoor PM_2.5 in buildings. This study used an algorithm to automatically estimate the long-term time-resolved indoor PM_2.5 of outdoor and indoor origin in real apartments with natural ventilation. The inputs for the algorithm were only the time-resolved indoor/outdoor PM_2.5 concentrations and occupants’ window actions, which were easily obtained from the low-cost sensors. This study first applied the algorithm in an apartment in Tianjin, China. The indoor/outdoor contribution to the gross indoor exposure and time-resolved infiltration factor were automatically estimated using the algorithm. The influence of outdoor PM_2.5 data source and algorithm parameters on the estimated results was analyzed. The algorithm was then applied in four other apartments located in Chongqing, Shenyang, Xi'an, and Urumqi to further demonstrate its feasibility. The results provided indirect evidence, such as the plausible explanations for seasonal and spatial variation, to partially support the success of the algorithm used in real apartments. Through the analysis, this study also identified several further development directions to facilitate the practical applications of the algorithm, such as robust long-term outdoor PM_2.5 monitoring using low-cost light-scattering sensors.     

基于工程状态标定的诊断载荷试验识别方法及应用

针对在役公路梁式桥梁由于材料性能退化及外部环境等因素共同作用而导致承载力不足、耐久性降低等问题,开展旧桥力学性能的快速诊断试验研究。通过诊断性载荷试验的理论分析和有限元模型标定流程研究,快速、高效地完成在役公路桥梁的承载力性能测量和评估,从而为在役公路桥梁结构的养护管理提供可靠的技术支持。     

高层建筑中上下相邻双层大跨度钢桁架施工技术

介绍了上海前滩10-01地块(办公及住宅)高层建筑上下相邻双层大跨度钢桁架施工技术。结合项目桁架结构特点,分析讨论了双层桁架的支撑措施布设及安装过程中的注意要点,解决了±0m楼板不能满足双层桁架荷载要求的问题,提出了待下层桁架支撑卸载后,利用下层桁架布设上层桁架支撑,完成上层桁架安装的方案。同时通过有限元计算分析,对桁架施工过程进行计算模拟,研究施工过程的结构位形及内力,保证施工质量与安全。     

The home environment in a nationwide sample of multi-family buildings in Sweden: associations with ocular,nasal, throat and dermal symptoms,headache, and fatigue among adults

Risk factors at home for ocular, nasal, throat and dermal symptoms, headache, and fatigue were studied in a nationwide questionnaire survey in Sweden, the BETSI study in 2006. Totally, 5775 adults from a stratified random sample of multi-family buildings participated. Associations between home environment factors and weekly symptoms were analyzed by multi-level logistic regression. In total, 8.3% had ocular symptoms; 11.9% nasal symptoms; 7.1% throat symptoms; 11.9% dermal symptoms; 8.5% headache and 23.1% fatigue. Subjects in colder climate zones had more mucosal and throat symptoms but less fatigue and ocular symptoms. Rented apartments had poorer indoor environment than self-owned apartments. Those living in buildings constructed from 1961 to 1985 had most symptoms. Building dampness, mold and mold odor were risk factors, especially headache and ocular symptoms. Lack of mechanical ventilation system was another risk factor, especially for headache. Environmental tobacco smoke (ETS), electric radiators, and crowdedness were other risk factors. Oiled wooden floors, recent indoor painting, and new floor materials were negatively associated with symptoms. In conclusion, building dampness, mold, poor ventilation conditions, crowdedness, ETS, and emissions from electric radiators in apartments in Sweden can increase the risk of ocular, nasal, throat and dermal symptoms, headache, and fatigue.     

一种基于GN算法的动态图划分方法

随着图规模的急剧增长，对动态图进行实时处理的需求日益增加。大多现有的算法针对静态图划分是有效的，直接用其处理动态图会带来较大的通信开销。针对该问题，提出一种基于GN算法的动态图划分方法。首先收集一段时间内加入动态图中的顶点；然后，利用GN算法对这些新加入的顶点进行预划分，产生若干个内部联系紧密的社区；最后，将预划分产生的社区结果插入到已经划分好的当前图中。实验从交叉边数和负载均衡度两方面将该方法与传统流式划分方法进行比较，结果表明， 在公开数据集上，该方法的交叉边数降低了13%，负载均衡度减少了42.3%。由此可见，该方法的划分质量明显优于传统的流式划分方法。     

循环水替代7℃水在氯乙烯精馏装置中的应用研究

详细计算了PVC生产精馏系统换热设备的热负荷、循环水量及运行成本,认为通过调整系统的运行温度和压力,精馏装置使用循环水替代7℃水具有可行性,这将有利于突破能耗高的技术瓶颈,最大程度地发挥节能降耗、减污增效的潜能。     

基于虚拟格网的建筑物点云轮廓线自动提取

在分析现有轮廓线提取方法不足的基础上，提出基于虚拟格网的建筑物轮廓线自动提取方法。该方法利用建筑物点云生成虚拟格网并进行二值填充；采用邻域分析方法进行边界格网的标记与追踪；为了避免边界追踪错误，设计了基于方向的单边缘格网抑制方法及基于距离的连接关系调整方法以改善提取结果质量；根据格网追踪结果，从原始建筑物点云中提取真实轮廓点以保持原始建筑物轮廓形态；采用随机抽样一致性估计及最小二乘拟合方法进行轮廓线规则化处理，实现建筑物轮廓线的自动提取。实验结果表明，该方法能快速从建筑物点云中提取轮廓线，可为建筑物轮廓线的自动提取提供一种可行的解决方案。